Part deflection can occur on most materials when excessive clamping forces are used. Excessive pressure causes warping of the workpiece. The only effective way to control part deflection is by applying consistent clamping force, adequate but not excessive. The Repeater eliminates inconsistent clamping forces every time - from vise to vise, from operator to operator.

Clamped before machining

We recommend using the Calibration Gauge to verify pressure settings, allowing for minor differences between Repeaters and between vises.
Note the psi reading on your traveler so you can set your Repeater on your next run.

For light machining of thin walled or plastic parts where only minimal pressure is necessary.

|The Repeater| |Calibration Gauges| |Job Knob| |Arbor Press Load Cell| |The Super Vise|