1- 3/4" Repeater & 1- Calibration Gauge

• THE REPEATER VISE HANDLE
  
  THE REPEATER VISE HANDLE IS DESIGNED FOR LIGHT CLAMPING WHERE REPEATABLE PRESSURES ARE CRITICAL. IT IS ESPECIALLY USEFUL WITH PLASTICS AND THIN WALLED PARTS WHERE DEFLECTION CAN OCCUR.
  

  THE REPEATER IS WARRANTED FOR THIRTY DAYS IF IT IS NOT OBVIOUSLY
  ABUSED.
  

  THE REPEATER IS NOT SEALED AND MUST NOT BE LEFT IN THE MACHINE WHEN RUNNING COOLANT. THIS WILL VOID THE WARRANTY.
  
  

  INSTRUCTIONS FOR USE
  
  

  TIGHTEN VISE WITH STANDARD HANDLE TO DESIRED PRESSURE USING THE CALIBRATION GAUGE.
  

  IF YOU HAVE NOT PURCHASED THE CALIBRATION GAUGE SET THE REPEATER AT A LOW SETTING AND INCREASE THE SETTING UNTIL THE REPEATER INCREASES THE PRESSURE THEN BACK OFF ONE NUMBER SETTING.
  

  MAKE A NOTE ON YOUR TRAVELER OF THE REPEATER SETTING OR PREFERABLY THE PSI READING.
  

  WE HIGHLY RECOMMEND THE USE OF THE CALIBRATION GAUGE BECAUSE OF VARIENCES BETWEEN REPEATERS WHEN USING MULTIPLE REPEATERS AND BECAUSE REPEATERS WILL LOSE FORCE AS THEY WEAR IN.

  
  

Part deflection can occur on most materials when excessive clamping forces are used. Excessive pressure causes warping of the workpiece. The only effective way to control part deflection is by applying consistent clamping force, adequate but not excessive. The Repeater eliminates inconsistent clamping forces every time - from vise to vise, from operator to operator.

We recommend using the Calibration Gauge to verify pressure settings, allowing for minor differences between Repeaters and between vises.
Note the psi reading on your traveler so you can set your Repeater on your next run.

Now offered in different pressure ranges. Torque was measured on 6" Kurt Vise.